• Version
• Download 173
• File Size 7.78 KB
• File Count 1
• Create Date August 24, 2021
• Last Updated September 26, 2021

PLME_7.0.ino: For Module 01M11V0 MNV Adjust

Note: Rather than an example, this is a programme to be run to adjust parameters and compensate for errors.

This program made by https://controlduino.com/ runs on an arduino UNO, MEGA and others,
Target:
The aim of this program is to adjust and calibrate the lambda module (Controlduino 01M11V00), to compensate for errors, as well as to modify the module parameters in the non-volatile memory, so that they are not erased at Power on reset.
Adjustment and calibration is used to eliminate all errors such as: pressure variation with height, manufacturing tolerances of the wideband lambda sensor and the module ..... adjusting the air to 20.95% oxygen.
The values of the non-volatile memory of the module are set to make the following adjustments:
• Set the filtering value.
• Set the auto-off time of the module.
• Enable/disable the pressure compensation.
• Adjustment and calibration parameters.

Hardware required to use this software:
• Arduino board
• Lambda module and wires.(Controlduino 01M11V00)
• Wideband lambda probe
• Power supply (V=12v, I>=2A)
On the website https://controlduino.com/ you can find all the information about the lambda modules and Shield and other modules.
Library:
To use this software you need to have installed the "Lambda" library which can be downloaded at: https://controlduino.com/lambda-module-01m11v00/
Purchase:
In the store https://controlduino.com/store/ you can purchase, lambda shields and lambda modules, sensors, and other modules.
Downloads:
In the following link you can download all the arduino files, smartphone APPs, data sheets about the board, and probes... :
https://controlduino.com/lambda-module-01m11v00/
Forum:
If you have any questions or want to share your projects you can do it in the forum: https://controlduino.com/forum/

Enjoy