PLME_2.0.ino: For Module 01M11V0 Basic + adjustment of air.

August 28, 2021
| No Comments
[featured_image]
Download
Download is available until [expire_date]
  • Version
  • Download 256
  • File Size 5.50 KB
  • File Count 1
  • Create Date August 28, 2021
  • Last Updated September 26, 2021

PLME_2.0.ino: For Module 01M11V0 Basic + adjustment of air.

The aim of this program is to measure the %O2 data of a gas coming from the combustion obtained from the lambda module (Controlduino 01M11V00) and display it on the serial monitor of the arduino, also sends battery voltage, status, and diagnostics.

Adjust when a "1" is sent from the arduino serial monitor. This allows the air to be set to 20.95% oxygen, to compensate for probe and components errors, and pressure due to geodetic altitude.....

This adjustment is fixed in the non-volatile memory of the module, so it will only be adjusted the first time the set is used, if the lambda probe is changed, if the module is changed, or if it is observed that the air measurement differs a lot from 20.95% oxygen. This adjustment should be made when in measuring state, and with the probe in clean air the oxygen, lambda or AFR output value is stabilised.